2017年8月31日星期四

Weather the quality of the cooling tower packing is good and bad affecting the cooling tower

610mm,813mm,915mm, 1220mm, 1520mm Marley cooling tower MX75 film fill
Cooling tower packing manufacturers to bring you more information about the cooling towers. Filling is the most important part of the cooling tower, its efficiency depends on the cooling water and air in the filler full contact with the degree. Cooling tower with S-wave type, point wave type, leaching filler, etc., is to recommend you a high-quality cooling tower packing company, it is Hebei LongTime Co., Ltd., the company's cooling tower packing full use of trapezoidal ramp Of the rational design principles, while increasing the number of water film closure, so that the water film repeatedly re-distribution and more even more uniform. Increase the vertical embossed wave, improve the horizontal diffusion ability of water film. So that in the filler water vapor heat exchange full. At the same time to slow down the water film, to extend the heat and mass exchange time, improve the cooling effect, packing film from the large, light weight per unit volume, to prevent the blockage of pollutants. Water contact area is large, long process, horizontal diffusion ability, so that the distribution of water film more uniform, light assembly quality, high load strength.
EAC cooling tower replacement pvc fills
       Filling is the most important part of the cooling tower, its efficiency depends on the cooling water and air in the filler full contact with the degree. The company's filler temperature 50 ℃ ~ 68 ℃, anti-aging, excellent performance, long life. Its advantages are as follows:
1, good heat exchange performance, high cooling efficiency
The filler is a thin film type, and the fine ripples of the protrusion make the water contact surface larger. The filler is placed in five layers, and there is a redistribution process between the layers and the layers.
Spindle cooling tower fill
2, good hydrophilic, small ventilation resistance
The surface is rough, the smooth surface of the filler is hydrophilic, water absorption is less than 0.015%, so that more water to form a thin film, without splashing, so that water and air more fully contact while the water and air flow in the surface disturbance Big. After the packing is assembled, the air inlet is a honeycomb-shaped deflector, and the cloth is well drained, and the heat exchange strength of the water vapor is improved and stabilized.
The inclination of the inlet end is 30 °, which effectively reduces the loss of water. At the end of the packing, a water dispenser designed according to the impact separation method is provided so that the water loss is effectively controlled within one ten thousandths.
grey cross flow cooling tower fill
3, easy installation, easy to clean, easy to transport
For more information, please visit our website: www.coolingtowerfiller.com, or contact us with E-mail, our E-mail address is rask@coolingtowerfiller.com, you can also chat us straightly on whatsapp: 008618330029204, you can also call our boss straightly: 008615930159213

没有评论:

发表评论

closed type cooling tower

new 1000*1300mm spindle cooling tower pvc fill pack Cooling Tower has roots inside the cooling tower industry that span again greater t...