Thermal and Resistance Characteristics of Cooling Tower Filling

Cooling tower filler thermal and resistance characteristics, generally in the indoor simulation tower test. Simulation is not model similar. That is not the prototype of the narrow, so it is not on the scale and similarity of the law it is to cut out from the original body of a typical block for the test, so the water area is much smaller than the original body, and no original body And the influence of the side wall of the test tower, so the indoor simulation tower test results and industrial towers are not the same (test method described later). General thermal performance test results are better than the industrial tower, so the design should be used to take a reduction factor. The size of the reduction factor depends on the comparison of the industrial tower test results with the simulation test. In determining the thermal characteristics of the cooling tower filler, the water distribution part, the cooling tower filler part and the cooling tower filler under the rain part of the distinction, so as to correctly reflect the thermal characteristics of the various parts. But in our country are still not to do so, but will. Dagger three parts together. So this book gives the cooling tower filler thermal characteristics, in fact, the three parts of the common results. The resistance data is only the resistance of the cooling tower filler part. Heat and resistance two results do not correspond, this is a drawback.
For more information, please visit our website: www.coolingtowerfiller.com, or contact us with E-mail, our E-mail address is rask@coolingtowerfiller.com, you can also chat us straightly on whatsapp: 008618330029204