Square Cooling Tower Manufacturers

square cooling tower packing media
Evaporative (FRP) Cooling towers are of vertical induced draft counterflow design with uniform water distribution and optimal heat transfer. Towers could be put in unbiased of wind direction.
The tower casing is fabricated from tough fibreglass strengthened plastic (FRP) and has ample structural power to withstand high wind velocities and vibrations. UV – stabilised resin is used together with gel coat for longer life. It’s resistant to local impacts and even if slight damage happens, local repairs can easily be performed. The portion of casing housing fill and eliminator has a round cross section. The water assortment sump, also of FRP, is leak proof & avoids water spillage.
cooling tower pvc filling
The fill is of inflexible Poly Vinyl Chloride (PVC) and is of honeycomb design with very large contact surface space. The fill splits the air and water into several streams, growing the time of contact and in addition heat switch between water and air. The fill is in modules and is packed in the tower casing with none slicing for curves. The air strain drop by means of the fill is negligible. The fills can be found with flute height of 6mm, 12mm, and 19mm with sheet thickness of 1mm and 1.2mm.
SCSP Nozzles:
The performance of cooling tower drastically depends upon the water distribution over the fills. SCSP nozzles distribute water evenly by a wide spray angle with none dry pockets. They’re lightweight and cut back the frequency of clogging. The Stable Cone Square Sample (SCSP) nozzles produce a stable cone spray of water that’s distributed in a square sample onto the fills.
pp plastic heilex ring for Air Purification
Drift Eliminator:
Reduces carry over losses of water. The eliminator is of rigid PVC (Applicable for square type cooling tower). The individual drift eliminators of S-shaped corrugated sheets are bonded with subsequent layers to create the structure. Your complete space is thus divided into several fine S formed mini zones each eradicating water droplets on the entire surface of the cell.
Axial Fan:
Specially designed energy environment friendly followers are of induced-draft axial type with adjustable pitch. Materials chosen are non corrosive of plastic, FRP or aluminium alloy. The high efficiency design ensures low operating value and the lowest potential noise stage. Fan blade pitch is manufacturing unit set and dynamically balanced.
new product 760mm Marley cooling tower Polypropylene fill
Motors:
The motors are completely enclosed (IP55), flange sort, 415 V, 3 ph, 50 Hz, induction weather proof with SS304 extended shaft and are specially designed for cooling tower software
Corrosion Free:
The tower casing is of FRP, fill and eliminator are of PVC, and SS304 fasteners are used, thus eliminating corrosion, the most important enemy of cooling tower. All steel parts comparable to motor help, water distribution pipes, hardware etc., are scorching dip or spray galvanized.
Lightweight:
The towers are compact and light weight resulting in easy delivery to site and installation. Gentle weight also saves on structural and masonry. Roof installation will also be performed with none special reinforcements.

cooling tower pvc filler
Set up, Service & Maintenance:
Towers of decrease capacity are utterly factory assembled earlier than despatch. At site the tower has simply to be bolted, on the RCC / brick masonry foundation, thus saving a variety of installation time. Towers of upper capability can simply be assembled at site and then put in in a way just like small towers. Upkeep is significantly reduced because fan, sprinkler fill and eliminator can simply be approached from the top with out disturbing the cooling tower casing.

For more information, please visit our website: www.coolingtowerfiller.com, or contact us with E-mail, our E-mail address is ann@longtimefrp.com, you can also chat us straightly on whatsapp: 008618330029204, you can also call our boss straightly: 008615930159213