Vertical Flow cooling tower film fill media
1. Check the exhaust fan motor and transmission belt maintenance; (motor, V-shaped belt,)
two. Water cleaning and maintenance; (cleaning water dispenser, washing heat deflector, heat sink scaling or off)
three. Water valve maintenance; (adjust the water float, check the water valve opening degree)
pvc fills of cooling tower
four. Water quality replacement (regular replacement of circulating water,)
Fives. Metal parts cleaning anti-embroidered treatment.
About maintenance
1) V-belt of the blower may be slightly elongated during the initial run. Please adjust the belt according to the adjustment method. If the belt is too tight, it will damage the bearing and cause the accident.
2) Please regularly clean the upper part of the sink water hole, the next sink filter and so on.
cooling tower RT pvc fill sheet
3) Please release the belt when transporting, blower bearing the Department of fuel, and cover the motor. In the initial operation to determine the belt tightening, locking nuts, and in the blower bearing the Department of refueling, but also to confirm whether the tower has a bird's nest or foreign body, and then boot operation.
4) exchange circulating water at least twice a year.
5) After evaporation of the circulating water, it will leave the dissolved matter in the water, so that the water concentration increases, the water is concentrated after the corrosive increase, increase the scale, so that the cooling tower capacity is low, piping and equipment damage.
In order to prevent this situation, it is recommended to use a part of the method of circulating water to solve:
pp plastic heilex ring for Air Purification
① running in the drain valve only open a little (run off when the switch off the drain valve);
② the lower part of the sink cleaning and regular change of water;
③ to run the water level rise, often overflow;
④ assembly automatic water changing device.
Precautions during winter transportation
1) discharge of circulating water and scattered water.
width 380mm bac counter flow cooling tower pvc fill
2) In the case of closed type, please open the drain water of the circulating water, the exhaust port and the water pump. Precautions for winter operation When the winter is running, the motor current will increase, please note. To prevent freezing of the lower sink, use an antifreeze heater. Water pump, piping the use of heaters, and do the bottom of the water tank insulation work.
Low Price PP PE PVC HDPE Teller Rosette Ring used in Chemical Tower
For more information, please visit our website: www.coolingtowerfiller.com, or contact us with E-mail, our E-mail address is rask@coolingtowerfiller.com, you can also chat us straightly on whatsapp: 008618330029204, you can also call our boss straightly: 008615930159213
订阅:
博文评论 (Atom)
closed type cooling tower
new 1000*1300mm spindle cooling tower pvc fill pack Cooling Tower has roots inside the cooling tower industry that span again greater t...
-
new type Marley cooling tower pvc filler For the reason that cylinder chamber is open to the discharge manifold, no refrigerant gasoline c...
-
750 x 2000mm Kuken cooling tower pp filling Cooling towers are heat rejection devices. They are integral to many refrigeration programs in...
没有评论:
发表评论