There are two ways to maintain and maintain the water dispenser nozzle. First, manual method: maintenance, the nozzle will be disassembled, the plug in the nozzle of the debris clean up, clean with water, re-assembled can be. Second, the chemical cleaning method: the water dispenser nozzle removed from the equipment after the release to a good concentration of 20% to 30% sulfuric acid aqueous solution, soak for 60min, and then rinse with water, the residual sulfuric acid solution in the nozzle After cleaning, soak the nozzle into the water, with the test paper to test its pH, to 7:00 when qualified.
2. Water dispenser sprinkler maintenance and maintenance
After the cooling tower is stopped every year, maintenance and maintenance of the sprinkler is carried out while maintaining the nozzle. The practice is: after the annual shutdown immediately after its rust, brush anti-rust paint, spray pipe and nozzle assembly of the wire head, available mercury Ming paint brushing, do rust treatment.
3. Cooling tower fan impeller, blade maintenance and maintenance
After the cooling tower stops running every year, the cooling tower fan impeller, the blade should be removed, the manual method to remove the corrosive material to do static balance check, evenly brushing anti-rust paint and phenolic paint again, and then the cooling tower fan Impeller, leaves back in place to prevent deformation.
In order to prevent large diameter FRP cooling tower fan blades are subjected to snow weight deformation, the blade angle can be rotated by 90%. So that it can be perpendicular to the ground. If you want to save the leaves decomposition, should be flat, not piling up.
If you have other questions about cooling tower, you can send E-mail to rask@coolingtowerfiller.com, you can also chat with us straightly on whatsapp:008618330029204
没有评论:
发表评论